SURUGA SEIKI Laser Holders

F511L: fixed type. F512L, F513L: YZ axis adjustable LD holder. Select according to the number of pins and the pin pitch (pin P.C.D.) of the LD.

[Features]
· Can adjust the tilt angle of small sensors and laser pointers.
· P.C.D.32 tapped holes are included on the holder surface. Uses these to mount various types of adapter plate.

[Features]
· A Chip Carrier type LD holder with a built-in Peltier element.
· Features a built-in Peltier element, and a calibrated 10kΩ thermistor sensor.
· The switching for the anode/cathode of the LD can be configured by replacing the jumper pins.
· There are two types of Chip Carrier LD holder. Configure according to the mounting (output) direction of the LD.
· For connectors, a D-sub9 pin female is used for driving the LD, and a D-sub9 pin male is used for the temperature controller.
· The F129-1 water cooling adapter is also available.
· Use a low temperature circulating water tank or similar to enable greater stabilization and for even lower temperatures.

[Features]
· A To-Package type LD holder with a built-in Peltier element.
· Features a built-in Peltier element, and a calibrated 10kΩ thermistor sensor.
· Supports LD sizes of ø5.6 (Pin PCD, 2.0) and ø9.0 (Pin PCD, 2.54) for three-pins and for four-pins respectively.
· For common anodes and common cathodes, etc., configure by replacing the jumper pins.
· For connectors, a D-sub9 pin female is used for driving the LD, and a D-sub9 pin male is used for the temperature controller.
· The F129-1 water cooling adapter is also available.
· Use a low temperature circulating water tank or similar to enable greater stabilization and for even lower temperatures.

[Features]
· F20 sandwiches the laser between three screws. The optical axis is adjusted by screwing in and out.
· With F21, in addition to the function of F20, it is possible to adjust in the θy direction by operating the screw at the bottom of the holder.
· Both F20 and F21 have two types, L=150 and 250, depending on the length of the laser.
· The included standard rod has a diameter of ø20 and a length of 60, but both the rod diameter and length can be changed upon request.
· The laser holding part can be fixed to positions at 50 mm intervals by removing the fixing screw from the bottom (only F20-150/250).
· The F20 can be attached directly to the breadboard (A65) by removing the rod.

[Features]
· A water cooling adapter for F125/F126/F127 LD holders
· Connect to water tanks which circulate water at low temperatures to enable superior temperature stability and low temperature control.
· Connect using a 1/4 inch hose (hose not included)