Guidance Sensor For AGV (Automatic Guided Vehicle)

This sensor is for guiding an automatic guided vehicle (AGV) along its route to the desired location by detecting the magnetic flux of the guide tape (rubber magnet) laid down on the floor.
[Features]
· Because the sensor is non-contact, it is not affected by dust, dirt, oil, etc.
· The guidance sensor works by detecting magnetism from a guide tape that is laid out over carpeting or other nonmagnetic material.
· Standard object detected: GT-100 series, GT-110 series, GT-600, GT-601
· Detection sensitivity: 0.5 mT±0.1 mT
· Operable distance: 0 to 35 mm (from the magnet surface to the sensor detection surface)
· Standard mounting distance: 25 mm (from the magnet surface to the sensor detection surface)
· Output capacity: 50 VDC, 50 mA or less
· Residual voltage: 0.5 V or less
· Operating temperature range: -10 to +50°C (without freezing or condensation)
· Effect of temperature: 0.05 mT / 10°C or less
· Operating humidity range: 10 to 90% RH (without freezing or condensation)
· Hysteresis: 0.03 mT or less
· Response time: 0.3 ms or less
· Protection circuit: power supply reverse connection, output surge absorption
· Effect of voltage: 0.03 mT or less in power supply voltage range
· Protective structure: IP-54
· The maximum number of elements is 7 or 15, depending on the model. However, it is possible to install only the number you need.