[ M ] Material: Cover of the Heater : SUS430
Mica for Insulation : Synthetic Mica
Nickel-chrome Wire : Nickel Chrome Ribbon Wire
Lead Wire : Nickel Copper Coated Wire
Lead Wire Heat Resistance Temperature: 180°C
[ A ] Accessory: Insulation Glass
(MBHS: 2 pcs. / MBHD: 4 pcs.)
Specifications
More Information
■Features
- The band heater is a thin cylinder heater, coated with stainless steel plate, whose nickel-chrome wire is insulated with the heat-resistant mica board.
- One-piece type and two-piece type are available for different diameters of the heated object.
One-piece Type: Suitable for the cylinder of small diameter. 1 unit (2 pcs.) of terminals are included.
Two-piece Type: Suitable for the cylinders of relatively large diameter. 2 units (4 pcs.) of terminals are included.
- Max Operation Temperature: 300°C
■Usage
-Band heater can be used for cylinder shaped heated objects (work).
-Principal usages are: Heating of hot nozzles, pipes and cylinder shaped metal plates
■Precautions for Use
[ ! ] Do not let the heaters run in open air, for that will cause fires and heater element damages.
[ ! ] Apply electric power under the condition in which an object such as metal to be heated is attached to the heater.
[ ! ] Attach the object so that the heater comes into close contact with the surface to be heated.
A gap will cause premature breakage of wire.
[ ! ] After installation, energize it for several minutes, and tighten them once more after heated.
At that time, take care not to be burnt.
[ ! ] The heater is not waterproof. Avoid water splashes on the heaters.
[ ! ] Do not use over the rated voltage (V).
[ ! ] Use the temperature controller for safety.
[ ! ] Do not mount One-piece Type flat.
(Put the heated object through the heater.)
Example
How can we improve?
How can we improve?